horizontall y, approximately 1 meter above the ground.
2)
Otherwise, the reel can use vertically when you hang in an
overhead suitable beam or rafter
(Fig.3).
3) The reel in the lower bracket
pin must be fixed with a bolt or
lock to secure the safet y. The
mounting bracket has 2 holes, to
the two holes on both ends there is a M8 Dyan Bolts
corresponds. Each bolt must be with spring washer or padding
(Fig4). Position of the two holes please sees Fig.5 (measurement in
mm).
3
.
ATTENTION POINTS FOR HOSE USE
The reel has a high quality kink resistant hose supplied.
1.
After use, turn off the air to allow for easy retraction.
2.
It is the best way to turn off the air before retracting the hose.
3.
Do not leave the reel in the outside during very low temperature. Under
low temperature conditions, the hose may be less flexible and difficult
to retract.
4.
Do not allow the hose to touch any chemicals or substances, such as
acetone, white spirits, acids etc.
4.
HOW TO RETRACT HOSE CORRECTLY
This reel is fitted with ratchet wheel and detent design and a safety lock at
the side of reel, making it easy to extend and retract the hose. While
pulling out the hose, you can hear the repeated ratchet mechanism sound.
When you pull out the hose length needed and hear the ratchet mechanism
engage, the hose will remain at the desired length. When you retract the
hose, pull out about 300MM and when no ratchet mechanism can be heard;
you can retract the hose. To retract, please ensure a minimum of 25% of the
hose has been extended. During retraction, always hold the hose and follow
the retraction until it is finished to prevent injur y. If the hose
twists, it is necessary to extend the hose to its full length then
allow it to retract evenly back into the reel.
5.
MAINTENANCE
Fig.4 Fig.5
Fig.3
