background image

ENG

USER’S INSTRUCTIONS

20

12.2.

INTERCOM VOLUME ADJUSTMENT

The volume level can be adjusted when the 

SCS 3LOGY

systems are in intercom mode. Pressing the control button [(1) see fig-1] changes

between three volume levels (low 

medium 

high 

low 

etc.).

13.

SUOMY SCS 3LOGY TECHNICAL SPECIFICATIONS

Bluetooth®: 2.1 Class 2 Profiles: A2DP, HSP, HPF, EDR.
Battery: lithium polymers, up to 6 hours of conversation, 200 hours in standby.

14.

WARNING

The 

SCS 3LOGY

is equipped with the most recent technology and has been manufactured according to the highest standards. 

The following instructions will ensure that the device is not damaged inadvertently:

• Do not try to open the device or its components as the internal electronics could be damaged. Attempting to open or change the battery could

be dangerous.

• Keep the device out of the reach of children.
• Keep the 

SCS 3LOGY

in a dry place. Dampness or condensation could damage the electronic circuits.

• Avoid extreme heat or cold. Intense cold could lead to the formation of internal condensation on returning to a normal temperature. High

temperatures could damage the battery, circuits or plastic parts.

• Do not drop, knock or shake the device as the internal circuits and mechanisms could be damaged.
• Do not paint or decorate the device as this could damage the plastic casing and prevent the device from functioning correctly.
• Do not use chemical products, solvents or detergents to clean the 

SCS 3LOGY

as the exterior could be damaged.

15.

TROUBLESHOOTING

If the 

SCS 3LOGY

does not connect to a mobile telephone ensure that:

• the 

SCS 3LOGY

has a charged battery, is switched on, and is connected to the mobile phone Bluetooth® device.

• The mobile telephone is on and has the Bluetooth® facility enabled.
• The mobile telephone and the 

SCS 3LOGY

are no further than 10 metres apart.

If the 

SCS 3LOGY

is not functioning correctly contact the retailer.

Please read the instructions contained in this manual on the safe, correct use of the device and keep the original receipt and completed
guarantee, as they must be shown to the retailer where the purchase was made, should repairs under guarantee be required.

15-24 Libretto TEC Bluetooth 3LOGY ENG:Layout 1  26-03-2012  12:15  Pagina 20

Summary of Contents for SCS 3LOGY











Reviews: