36
In order to protect travel mechanism, avoid turning while backing as possible as you can.
Travel direction mark
：
3.4.3 TRAVEL SPEED
When the machine is traveling, press high/low speed switch
⑥
on control panel( FIG 2-5), the
shift of travel motor high and low speed is achieved, then the machine can travel at high or low
speed.
3.4.4 TRAVEL BRAKE
Release travel pedal or travel handle, it will return to natural position automatically, the machine
stops traveling.
3.4.5 OUTLINE OF TRAVEL
1)
Avoid crossing over obstacles whenever possible. Because the machine may get injured
from the possible strike. If you must do so, keep the hoe attachment close to the ground and
stride over the obstacle slowly with the centre of the track.
2)
On uneven ground, travel at low speed and avoid accelerating, stopping or changing
directions abruptly.
3)
When working in water, check the depth of the water, make sure that the water’s depth is
not higher than the half of the track roller. Never dip the rear end of the machine into water.
⚫
If the lubricant parts need to work in water for a long time, add enough lubricant oil until
the old oil is replaced.
⚫
Never imerge the slew bearing in water or sand, if you have to do so, contact the dealer or
technician to confirm if this is allowed.
4)
Pay special attention to the balance when
traveling on a slope (the maximum grade ability
is 20°, maximum lateral tipping angle is 10°).
And you should note that when actual working
area conditions are poor, the machine’s stability
might be lower.
⚫
When traveling on slopes or grades, lower
the bucket to a height of 20 to 30cm. In
emergencies, lower the bucket to the ground and stop the machine.
⚫
When traveling on slopes or grades, move slowly in first gear (low speed).
⚫
Do not travel down slopes in reverse.
⚫
Do not change the directions or cross slopes sideways. First return to a flat surface, then
