Suntrica SolarStrap User Manual Download Page 2

Suntrica SolarStrap™

Congratulations on your purchase of Suntrica SolarStrap™, 

a solar powered charging device. Suntrica SolarStrap™ 

provides charging power to most devices having a charging 

voltage of 5 V DC, for example mobile phones, MP3 players, 

GPS devices, and digital cameras. The charging necessitates a 

device specific charging adapter, which can be purchased from 

your local distributor.

Before using SolarStrap™, carefully read this user guide and all

instructions and cautionary markings on SolarStrap™, the 

device to be charged, and the mains adapter for charging 

SolarStrap™.

This guide contains important safety and operating 

instructions. 

Important safety instructions

•  Read and observe all warnings on Suntrica SolarStrap™  

 

and in this user guide

•  Power consumption of the connected device must not  

 

exceed 5.5 V DC, 800 mA

•  Do not expose SolarStrap™ under water

•  Do not place inflammable, explosive or hazardous objects  

 

near SolarStrap™

•  Do not place any heavy objects on SolarStrap™

•  Do not bend solar panel heavily

•  Only use Suntrica charging cables and accessories with  

 

SolarStrap™

•   

Charging of the SolarStrap™ from 12 V DC with a ciga-

rette lighter cable other than approved by Suntrica Ltd. 

is strictly prohibited. Use of any non-approved cable 

may damage the SolarStrap™ permanently

•  Only use SolarStrap™ in an environment with the proper  

 

temperature (+0...+50 °C)

•  Do not use SolarStrap™ if it has been subjected to damage

•  Unplug SolarStrap™ from the mains power adapter when  

 

cleaning and when the battery is fully charged.

• 

Unplug the charging cable from SolarStrap™ when not in  

 

use

•  Allow a sufficient amount of free space all around 

 

SolarStrap™ and ensure adequate ventilation

•  SolarStrap™ should not be disposed by burning or with  

 

other household wastes

Functional overview

Figure A and B:

 

Suntrica SolarStrap™ gathers solar energy by the high 

efficiency solar panel and stores the energy into a light-weight 

battery. Green and red lights indicate the charging level of 

the internal battery, and the status of a charging circuitry. The 

Input/output connector is used for:

•   charging a target device

•   fast-charging the internal battery

The back side of SolarStrap™ contains a hook-and-loop 

fastener tape for locking SolarStrap™ in a folded position, and 

also for allowing easy attachment to various surfaces, e.g. to 

clothes and back bags.

Figure C: 

SolarStrap™ provides charging power to most devices with a 

charging voltage of 5 V DC.

Figure D:

SolarStrap™ can be fast charged using a mains adapter 

available as an accessory.

How to charge with SolarStrap™

1.  Connect the charging cable to the target device     

2.  Connect the other end of the charging cable to 

 

SolarStrap™

3.  Charging begins, this is indicated with two pulses of red  

 

light blinked at few seconds intervals  

4.  After the target device is fully charged or the internal 

 

battery is empty (please, see charging level indication),  

 

remove the charging cable from both devices

Full SolarStrap™ can fully charge a typical mobile phone. The 

charging time is approximately similar with the mobile phone’s 

own charging device. The charging feature is disabled, if the 

internal battery is empty. Plugging of the charging cable to the 

SolarStrap™ increases the power consumption of the 

electronics. Therefore, unplug the charging cable from 

SolarStrap™ when not in use

Charging level indication

The green and red lights indicate the approximate charging 

level of an internal battery by regular blinks. The approximate 

charging level is interpreted as follows:

Solar powered charging

Energy gathering from the light begins instantly, when 

SolarStrap™ is placed in light. Optimal charging performance 

is achieved outdoors in direct sunlight. Clouds and shadowing 

reduce the charging performance notably. The approximate 

performance of solar powered charging is presented in the  

following figure. The figure indicates approximate charging 

time of an empty internal battery until the battery is full.

Charging using a mains adapter

When needed, the internal battery of SolarStrap™ can be fast

charged by a mains adapter (accessory). First, plug a mains 

adapter to an AC wall outlet, and then plug the charging plug 

to SolarStrap™. Continuously pulsing red light indicates that 

the fast-charging is in process. The red light turns off, when 

the charging is finished. The charging time is typically two 

hours.

Troubleshooting

Problem: 

SolarStrap™ does not charge a connected device

Possible cause:

Solution:

The internal battery is 

empty

Charge SolarStrap™ in sunlight or by a mains 

adapter until the green light blinks

SolarStrap™ or the 

charging adapter is not 

compatible with the 

connected device

Contact your local distributor for confirming 

the compatibility and for selecting a suitable 

charging adapter for your device

The current consumption 

of the device exceeds 

the rated output of 

SolarStrap™

Indication:

 The red light blinks five times.

Refer to the user manual of the device

Improper connection 

between device and 

SolarStrap™

Make sure that the charging cable is properly 

inserted into the device and SolarStrap™

Damaged charging cable

Replace the charging cable

Problems with the 

electrical circuits of 

SolarStrap™

Suntrica products have been tested in 

factory. If you suspect that the SolarStrap™ 

has been defected, please contact your local 

distributor

Problem: 

A mains adapter does not charge SolarStrap™

Possible cause:

Solution:

The internal battery is full

Indication:

 The green light blinks slowly 

four times after plugging the charger.

Check the charging level of the battery

The service voltage of the 

mains adapter does not 

correspond with that of 

SolarStrap™

For ensuring that the product works properly 

and the guarantee is not void, use only  

original Suntrica mains adapter and  

accessories

Improper connection 

between mains adapter 

and SolarStrap™

Make sure that the charging cable is properly 

inserted into SolarStrap™ 

Damaged mains adapter

Replace the mains adapter

Problems with the 

electrical circuits of 

SolarStrap™

Suntrica products have been tested in 

factory. If you suspect that the SolarStrap™ 

has been defected, please contact your local 

distributor

Maintenance

•  Use a soft cloth to clean SolarStrap™ exterior

•  Do not use harsh chemicals, cleaning solvents or strong  

 

detergents

•  Do not disassemble SolarStrap™

Technical specification 

Rated input (mains adapter)  5.0–6.0 V DC 

Rated output 

5.5 V DC, 800 mA 

Battery capacity 

3.7 Wh 

Operation temperature 

+0...+50 °C 

Size  

290 x 97 x 16 mm

 

 

144 x 97 x 27 mm (folded)

Weight 

60 g 

Correct disposal of the product

The marking shown on the product or its literature, indicates 

that it should not be disposed with other household wastes 

at the end of its working life. This product should be disposed 

similarly with any other product having batteries and electrical 

components. This product should not be mixed with other

wastes for disposal.

DECLARATION OF CONFORMITY

Hereby, Suntrica Ltd. declares that this SolarStrap™ product 

is in compliance with the essential requirements and other 

relevant provisions of Directive 2004/108/EC. 

 

© 2009 Suntrica. All rights reserved. Suntrica® and 

 

Suntrica SolarStrap™ are trademarks or registered trademarks 

of Suntrica Ltd. Suntrica Ltd. reserves all rights to any

 

changes 

to this User Guide and/or product specifications without a  

prior notice.

Descriptions for the numbers:

1.  Battery pack

2.  Hook-and-loop tape

3.  Input/output connector

4.  Green and red lights

5.  SolarStrap™ in folded position

6.  Solar panel

7.  Charging cable 

8.  Target device to be charged

9.  Mains adapter (available as accessory)

Blinks  

Description

 

 

Charging of a target device in process.

 

 

Charging cable connected and Solar Charger  

 

 

ready to charge a target device.

   

 

 

Blinks  

Charging level  Battery status

 

 

Full

 

 

Nearly full

 

 

Half full

 

 

Nearly empty

 

 

Empty

Contents of the box

Available accessories

• Suntrica SolarStrap™ 

• Charging cables

• Charging cable

• Mains adapter

• User Guide

• Target device specific adapters
• Cigarette lighter adapter

EN

WARRANTY

If you believe that you are entitled to a repair or replacement of your SUNTRICA product based on your statutory 

rights under the applicable national laws relating to the sale of consumer products or warranty given by the retailer  

who has sold the SUNTRICA product to you, please contact your retailer.

Your local distributor

Solar

Strap

User Guide

Suntrica

Weather condition

Charging time

12 hours 

24 hours 

5 days

Optimal solar charging position

In order to achieve the best possible charging performance 

SolarStrap™ should be positioned toward the sun.

!

Reviews: