Recommended Switch Settings
Function
Trigger
LTC
DEL
RAIN
SNOW LD OFF
LD ON
Snow sensor
w/o LTC
TT>AT
OFF
OFF
OFF
ON
2 Min
2 Min
Snow sensor
w/LTC
TT>AT>15°F (9.5°C)
ON
OFF
OFF
ON
2 Min
2 Min
Snow controller w/o LTC
TT>AT
OFF
ON
OFF
ON
30-90 Min
2-6 Hr
Snow controller w/LTC
TT>AT>15°F (9.5°C)
ON
ON
OFF
ON
30-90 Min
2-6 Hr
Do Not set the Rain switch to "ON". Possible overheating of the snow melt
cables may result.
Specifications
Supply Voltage
100 - 277 VAC
Maximum Amperage
2 x 30A
Trigger Temperature Range (TT)
34
0
F to 44
0
F (1
0
C to 6.5
0
C)
Configuration Modes
Snow Only
Rain Only
Snow or Rain
Delay Settings (post melting)
30 to 90 minutes
2 to 6 hours
Low Temperature Cutoff (LTC)
Prevents system operation when Ambient
Temperature (AT) is below 5°F (-15
0C
)
Operation Modes
Automatic Standby/Reset Manual
Sensor Maintenance
At least once every four months the PM 5 should be powered
down and the sensor grid be wiped clean with clear water. Heavy
deposits left behind by evaporated water may be removed by
gently scrubbing with a non-metallic scouring pad.
LOAD1
LOAD2
INPUT POWER
GRID JACK
SWITCH JACK
CONTROL/MONITOR JACK
SENSITIVITY ADJUST
DELAY OFF ADJUST
TEMPERATURE ADJUST
CONFIGURATION SWITCH
CDP-2
Deice On
Snow Sensor
Control/Display Panel
Standby
Automatic
Manual On
SYSTEMS
AUTOMATED
ENGINEERING
Indoor monitoring
and control of the PM 5
is available with
the optional PM DP
snow melt sensor
remote control.
For more information see
the PM DP submittal or
installation instructions.
120 / 208 /
240 / 277 VAC
Ground
L1
L2 / N
PM-5C
Snow Control
Waterproof
Junction
Box
Gr
Yellow
Blu
Brn
Red
Gr
Wh
ProMelt
Mat/
Cable
ProMelt
Mat/
Cable
Wh
Gr
Wh
Wh
Ground
L1
L2 / N
PM-5C Control
ProMelt Display Panel
WARNING: This product contains chemicals known to the State of
California to cause cancer and birth defects or other reproductive
harm. For more information: www.watts.com/prop65
M
anual Override Switch
An override switch is mounted on the side for testing and special
operational requirements. Placing the switch in the "Automatic"
position will allow the sensor to operate normally. "Manual On" will
activate the control and will stay activated for a maximum of 40
hours before returning to "Automatic" mode. The "Stand-by/Reset"
position will clear any current snow melt call or delay activity.
If the Manual Override Switch is moved to Manual On for less than
2 seconds and then back to Automatic the sensor will execute one
delay off cycle. This can be used to clear frost, hail, drifting snow, or
other conditions. Stand-by/Reset will clear this setting.
Limited Warranty: SunTouch (the “Company”) warrants each product to be free from defects in material and workmanship under normal usage for a period of one year from the date of original
shipment. In the event of such defects within the warranty period, the Company will, at its option, replace or recondition the product without charge.
THE WARRANTY SET FORTH HEREIN IS GIVEN EXPRESSLY AND IS THE ONLY WARRANTY GIVEN BY THE COMPANY WITH RESPECT TO THE PRODUCT. THE COMPANY MAKES NO OTHER WARRANTIES,
EXPRESS OR IMPLIED. THE COMPANY HEREBY SPECIFICALLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach of warranty, and the Company shall not be responsible for any incidental, special
or consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged if this product does not work properly, other costs resulting from
labor charges, delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which the Company has no control.
This warranty shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of the product.
Some States do not allow limitations on how long an implied warranty lasts, and some States do not allow the exclusion or limitation of incidental or consequential damages. Therefore the
above limitations may not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights that vary from State to State. You should consult applicable state
laws to determine your rights. SO FAR AS IS CONSISTENT WITH APPLICABLE STATE LAW, ANY IMPLIED WARRANTIES THAT MAY NOT BE DISCLAIMED, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL SHIPMENT.
IS-ST-PM5C
1730
© 2017 SunTouch
USA:
T: (888) 432-8932 • F: (417) 831-4067 • SunTouch.com
Canada:
T: (905) 332-4090 • F: (905) 332-7068
Latin America:
T: (52) 81-1001-8600
