Suntor ST6200TPS-SD, User Manual, Page: 1 / 6

1st
ST6200TPS-SD User Manual
I.
Precautions
Before using this system, please carefully read the following precautions to ensure the system can safely and reliably
work.

Before powering on the transmitter and receiver, make sure the antennas
are in good connection.

Before powering on, make sure distance between two antennas( TX & RX) longer than 10meters, or the electrical
level will be too high to damage the RX.

Selecting an appropriate installation location and try your best to make the RX antenna in higher place and its
directivity is in open air.

Do not disassemble the antenna until the power is turned off

Make sure the whole power supply system complies with the relevant technical requirements

Try your best to make the video source far away from the TX and avoid the parallel between video source cable
and TX antenna

Before using, make sure the battery is full charge. Because with low power the communication will be unstable
and the video will be discontinuous.

External power and the lithium battery can not be use at same time.

Please do not open the case to do some changes without any permission and guidance of supplier.

Please do not allow any metal objects to enter into the system shell
Remark
：

The system must be operated in a dry and ventilated environment.

The system settings are configured before leaving the factory. Do not change the parameters randomly.