DRAINAGE
During the process of cooling some water will be extracted from the air into the unit. If the reservoir is
full, both the compressor and motor will stop and the units would buzz (you can press any button to stop
the buzz), only the fan runs to circulate the air. The W.F. indicator will flash to show you.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and avoid
moving it while full.
2. Position a container (a water tray e.g.)
underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
4.
When the container is almost full,
replace the rubber plug in the drain hole
to stop the water and empty the water
tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit – the full water or
compressor indicator should not be
flashing.
2
By water tube (continuous drainage)
1. Remove the drain knob and rubber
plug and retain for future use.
2. Connect the drain tube supplied to the
water outlet as shown and locate the
other end into a drain.
3. The drain tube may be extended by
adding an extension tube and using a
suitable connector.
NOTE: The drain must be at or below the
outlet level. Flashing comp/”full water”
indicator will not function in this mode of
drainage. If you want to extend the water
tube connect it with another tube
(OD:18mm)