14
the heater.
Always use on a dry, suitably strong, stable, flat and level
surface
Check exterior walls for communication and electrical
cables and pipelines. Should any service lines be present
in the immediate vicinity - do not install your appliance; find
an alternative location to install this product.
Do not place the heater directly above or below an
electrical socket.
Do not remove any of the warning stickers or signs from the
product.
Installation
1. There are 4 brackets and fasteners inside the packaging which are to be used for the installation. Furthermore, in the
canal of back side of the appliance there are 4 square fastener washers 25×25mm. Take the square washers and fasten
2 brackets to the canal on the backside of the heater using the screws.
2. Fasten the brackets at the appropriate distance of each other (45-55cm).
Two other brackets are to be fastened using the fasteners at the appropriate distance on the wall parallel to the
floor (At least 1.8 m from the floor and at least 0.5 m from the ceiling).
4.
Join the brackets on the appliance with the brackets, fastened on the wall, with the help of figured screw-nuts. Install
the heater under necessary angle (in the direction to the area being heated).
Install the appliance strict in horizontal position only.
Safety Distances:
Minimum distances required for safety
Minimum distances from wall corners: 40cm Minimum distances from coverage area and other objects: 100cm
Right and wrong positions
Direct your appliance towards the most appropriate angle.
Do face the unit to the window, glasses etc. as the heater primarily heats the locations onto which its light falls. Prevent the
loss of directed heat through the windows.
Operating
Step 1
: Plug the power cord into the outlet.
Step 2
:
Click rocker switch to ▬ position and press Open/Close once, the digital screen shows P.0 which means power on.
Step 3
: Press Open/Close twice, the digital screen shows P.1 which means first power setting.
Step 4
: Press Open/Close 3 times, the digital screen shows P.2 which means second power setting.
Step 5
: Press Open/Close 4 times, the digital screen shows P.3 which means second power setting.
Step 6
: After the function is on, 1-24 hours timing shutdown can be adjusted. The digital screen showing 01 indicates
