READ AND SAVE THESE INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be followed including the following:
1. Use this fan only as described in this manual, other use not recommended may cause fire, electric shock or injury.
2. High Velocity fans are designed to create rapid air movement, therefore make sure the fan is not placed near
drapes, curtains or any objects that may be drawn into the fan inlet.
3. To protect against electrical shock, do not immerse unit, plug or cord in water or spray with liquids.
4. This appliance is not intended for use by children or other persons without assistance or supervision if their
physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure
that they do not play with the appliance.
5. Unplug the fan from the outlet when not in use, when moving fan from one location to another, servicing and before
cleaning.
6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure
that they do not play with the appliance.
7. Do not place the fan or any parts near an open flame, cooking or other heating appliance.
8. Avoid contact with moving fan parts.
9. To disconnect, grip the plug and pull it from the wall outlet, never yank the cord.
10. Always use on a dry level surface.
11. Do not hang or mount fan on a wall or ceiling.
12. Do not operate the fan without protective front and rear grilles in position.
13. Be careful not to place the fan too close to the edge of the surface.
14. Do not use outdoors.
15. Do not let the power cord hang over the edge of a table or counter or let is touch any hot surfaces.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
FAN ASSEMBLY
1. Install the U shaped tube to the height adjustment tube using screws.
2. Install the support tube to fan main body using screws.
3. Put the switch-box in the front of the right supporter.
OPERATION
1. Set your fan on a level dry surface.
2. Plug the power cord into a standard 230 V wall outlet.
3. To operate your fan, turn the control knob to the desired fan speed Low(1),Med(2)High(3)
4. Adjust the fan head to your desired angle.
