Website: www.sunsynk.com E-mail: [email protected]
9
7. OPERATION
Switch Positions:
Power ON – System live.
Night Only – System OFF during the day and ON during the night.
ON – System ON and ready to be used all the time.
LED Indicators:
Inverter ON – System OK and powered ON.
Night Only – System OFF during the day and ON during the night.
Full Charge – Batteries are fully charged.
Charging – Batteries are charging.
Buzzer Indicators:
“Beep…beep…” – System overload indication.
“Beep beep…beep beep…” – System low voltage indication.
“Beep beep beep… beep beep beep” – System high voltage indication.
“Beep beep beep beep…beep beep beep beep” – System high temperature indication.
“Beep beep beep beep beep…beep beep beep beep beep” – System short-circuit indication.
Once the PB 1000 has been fixed into a suitable location, solar panels wired, batteries connected, and
AC wired to a fuse board or power block, it is time to turn on the device.
7.1. Switching On
The two switches are positioned at the bottom of the
circuit board.
a) Left side switch (On Off) powers on the device
b) Right side switch ‘II’ selected sets night only and
when positioned in ‘I’ sets 24 hours on.
The user must turn on the PB 1000 and select
whether it should operate for 12 hours or 24 hours.
Then, the box cover should be closed and secured.
The device will not require any further adjustment.
Power On
In ve r ter On
Night Only
Full Charge
Charging
Night only
On
