Page | 8
5. USING THE PRODUCT
Fully Charge before using:
Plug the UPS into the main socket with the cable provided and leave to charge for up to 3 hours
before you initially use the product.
1) Check your device is suitable to run from the Lifelynk Mini (home emergency power pack)
2) Check the voltage and current your device uses (See section 1.2). Most common is 9V and
12V 0.6Amp to 1Amp (Devices above 1Amp are not suitable for this UPS)
3) Check the polarity of the cable. Normally, the metre is positive
(It will show on the adapter). If the center is negative, you will need
a special cable as it may damage your device
4) Select a suitable adapter for your device
5. Unplug your device from its original mains adapter and connect it to the new adapter cable.
6. Plug the other end into the Lifelynk, ensure you use the correct socket that matches the same
voltage of your device, using the wrong socket may damage your device
7. Connect the Lifelynk mini to the mains socket and switch on
8. Switch on the Lifelynk mini your device should power up immediately.
(If your device does not power up, unplug it and seek for advice)