4.2.1 To avoid the thief’s destruction, the tracker should be installed as covertly
as possible. Suggestions are as follow: a, Hidden area under the decoration board
below the front
windshield or back windshield; b, Shelter around the front instument panel (
non-metallic material face);
4.2.2 Avoid placing the device close to higher power electrical devices, such as
reversing radar,anti-sheft device or other vehicle cmmunication equipment.
4.2.3 alarms and other vehicle-carried communication terminals.
4.2.4 You can fix the tracker with the cable tie, or glue it with wide strong sponge
double-sided tapes.
4.2.5 Because the tracker has GSM and GPS antenna inside, please make sure the
reception side of GPS is upward (facing the sky), and there is no metal shelter above
the tracker.
Attention: If there is a metal insulation or a heating layer glued in the
windshield, it will reduce the efficiency of
5、Equipment connect the matters needing attention
5.1 Power、ACC line、Oil cut-off electric control line（7pin）
5.1.1
This equipment is standard for power supply
9V~24VDC，
please choose the
original provide power supply cord, red line power positive, the black line for power
negative; When installation, please choose to separate negative power grounding
wires or by iron, don't another ground were answered.
5.1.2 ACC line（Yellow）
Please connect device' ACC line with vehicle's ACC switch, the tracker will
determine vehicle status based on the state of ACC .starting or stationary, and
decided to upload interval, start time: 15s, still time: 5min.
5.1.3 Relay wiring instructions
Oil pump cut-off relay connection method
：Coil ends connection were thin white line
(85) and fine yellow line (86), thin white line (85) car power negative, thin yellow
line (86) joint terminal relay control line;
Accused of vehicles on the fuel cascading have oil pump, oil pump positive connecting
wire cut, oil pump is extreme cascading in relay normally closed end (coarse green line
87 a), the other end joint relay public end (coarse green line 30).
5.1.4 SOS line（2pin）
External SOS Switch button
，Used for emergency call for help；
5.1.5 Horn line（1pin）
External car horn, can realize two-way talkback。
5.1.6 MIC line（1pin）
External microphone, realize voice monitoring function;
5.2 please make sure to connect the power after the installation is complete;
5.3 concealed installation, power cable used original main power line, red line end
string has a fuse box (2A fuse) which can play a short circuit overcurrent protection
