3
15. Secure the Solar Panel to the EasyShade Housing
by inserting and tightening the provided Allen
set screw into the threaded opening under the
bottom edge of the Solar Panel.
16.
With your helper, lift the EasyShade Assembly up
to the installed mounting Brackets and insert the
top groove of the EasyShade assembly onto the
protruding tab on the mounting brackets. See
Figure 5
.
17. While maintaining upward pressure to keep the
top groove of the EasyShade Assembly on the tab
of the Mounting Brackets, press the EasyShade
Assembly toward the Mounting Bracket and be
sure that the set screw is aligned in the recessed
portion of the shade assembly. See
Figure 5
.
18.
Tighten the set screw in each mounting bracket
until the shade assembly is secure.
19. At each end of the EasyShade Housing Assembly
uncoil the Vinyl Coated Cable. Allow the coiled
cable to hang flat against the mounting surface.
20. Insert the Vinyl Coated Cable located at each end
of the Housing Assembly through the guide holes
at each end of the EasyShade Drop Down Fabric
Panel. See
Figure 3
.
21. Place the lower end of one of the Vinyl Coated
cables through the hole in the Cable Guide
Bracket and from the bottom slide one of the
Cable Guide Stops onto the Vinyl Coated Cable
and secure in place with the 5/64” Allen wrench.
Repeat for the other side of the EasyShade.
See
Figure 2
.
22.
Ensure the Vinyl Coated Cables are tight. Adjust
the tension using a 7/16” open end wrench as
follows. On each of the Cable Guide Stops you will
find 7/16” nut, by turning the nut counter clockwise
you can tighten the cable.
Note: DO NOT OVER TIGHTEN THE CABLE.
Connect the Motor Power Cord to the Solar Panel.
Test for proper operation. Enjoy.
APPENDIX A
REMOVAL OF SOLAR PANEL FROM
WALL MOUNT BRACKET
1. Disconnect the Power Cable between the Solar
Panel and EasyShade Motor.
2.
Loosen the Allen Set Screw (see
Figure 4
) under
the Solar Panel.
3.
Carefully slide the Solar Panel to the left or right
side, until it separates from the Bracket.
CAUTION: If the Solar Panel does not easily slide
off the Wall Mount Bracket, nudge it gently. Do not
use a hammer to bang the Solar Panel Assembly, as
permanent damage may occur.
WARNING: WHEN USING A LADDER OR ANY OTHER
CLIMBING DEVICE, YOU MUST USE EXTRA CAUTION
WHEN SLIDING THE PANEL OFF THE BRACKET.
WE RECOMMEND TO POSITION THE CLIMBING
DEVICE TO THE SIDE TOWARD WHICH YOU WILL BE
REMOVING THE PANEL. IT IS HIGHLY RECOMMENDED
TO HAVE A HELPER SECURE THE CLIMBING DEVICE.
FAILURE TO DO SO COULD RESULT IN A FALL AND IN
PERSONAL INJURY.
INSTALLATION OF SOLAR PANEL
TO WALL MOUNT BRACKET
1.
Center the Solar Panel in front of the Mounting
Bracket.
2.
Set the bottom of the Solar Panel against the
house, so the Allen Set Screw (see
Figure 4
) points
up toward the bottom of the Mounting Bracket.
3. Hook the lower edge of the Panel under the lower
edge of the Mounting Bracket. See
step 1
in
Figure
4
.
4. Press the top of the Solar Panel over the top of
the Mounting Bracket, so the top Lip of the Panel
snaps onto the top Groove of the Bracket. See
step 2
in
Figure 4
.
5. Tighten the Allen Set Screw, under the Solar Panel,
ensuring the Solar Panel is secured to the Bracket
and will not slide either left or right.
