For Technical Support visit us at ownerscorner.sunsetter.com
or Call Toll Free 800-670-7071 • Fax 877-224-4944
©SunSetter Products, 184 Charles Street, Malden, MA 02148
EASYSHADE
®
1. Close your EasyShade completely, if possible.
2. Disconnect the Power Cord from the Solar Panel.
Solar Panel Assembly
Replacement Instructions
* Helper Needed *
Tools Needed:
Phillips Screwdriver, 3mm Allen Wrench, 4mm Allen Wrench and a 5/64” Allen Wrench.
Parts Supplied:
Replacement motor
4. Pull the Vinyl Coated Cable out of the Guide Holes
in each end of the EasyShade drop down panel.
See
Figure 3
.
Figure 2
Cable Guide Stop
Cable Guide
Bracket
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY!
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE PERFORMING THIS PROCEDURE.
Figure 4
Masking
Tape
Vinyl Coated
Cable
Leading Bar
Housing
Figure 3
Guide Hole
Vinyl Coated
Cable
Fabric Panel
3.
Remove the Cable Guide Stops from the bottom
of the Vinyl Coated cables, on each side of the
EasyShade using a 5/64” Allen wrench. See
Figure 2
.
5. Coil the Vinyl Coated cable and secure with a
piece of masking tape. See
Figure 4
.
Figure 1
Note: If a Remote Wall Bracket (see
Figure 1) is used to mount the Solar Panel
direct to the wall (see Figure 2) instead
of mounting directly on the EasyShade
Housing, skip ahead to Appendix A.
Figure 2
Solar Panel
Allen Head
Set Screw
is located
below here.
Remote Wall Bracket
Note
: Step 6 requires access to the Mounting
Brackets for removal of the Housing from the house.
If the Fabric Panel can not be retracted out of the
way, have a helper assist you in rolling the Fabric
Panel around the bottom Leading Bar until the rolled
up Fabric and Leading Bar meet the Housing, then
secure it safely in place.
