RETRACTABLE AWNINGS
For Technical Support visit us at www.sunsetter.com/ownerscorner or Call Toll Free
800-670-7071 • Fax 877-224-4944
Outer and Inner Arm With Rafter Set Replacement
900
XT
and 1000
XT
Awning
Tools Needed: 7/16” wrench, 7/16” socket and ratchet, 7/32” Allen wrench, & flat screwdriver.
Parts Supplied: Outer/Inner Arm (Left or Right), Rafter Set (Left or Right)
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY!! PLEASE READ
THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING TO COMPLETE THIS PROCESS.
PLEASE NOTE THAT LEFT AND RIGHT REFERENCES ARE AS YOU ARE FACING THE HOUSE.
1. Using the Hand Crank Wand, unroll the Awning until the Fabric is
completely extended. Do not lock the Rafters. Place a chair or box
under the Roller Bar for support. See
Figure 1
.
Note:
If Arms and or Rafters on BOTH sides are to be replaced, more
than one chair or box should be used to evenly and safely support the
Roller Bar. See
Figure 1
.
Note:
Take notice of the positioning of the Drive Unit and Crank Loop.
See
Figure 5
.
2.
On the side needing replacement, remove the 1/4" nut and bolt that
secures the Rafter End to the Upper Bracket. See
Figure 2
3.
Carefully fold the Rafter set on top of the Arm.
4. Using a 7/32” Allen wrench, remove the Flat-head Cap Bolt that secures
the Arm and Rafter to the Roller Assembly. See
Figure 3.
5. Separate the Roller from the end of the Rafter and Arm. See
Figure 3
.
Note: If you are replacing the Right Rafter Set, make sure that the
Drive Unit is oriented so that the Crank Loop is pointing towards the
HOUSE. See Figure 4.
6. Remove the old Rafter Set from the Awning and replace with the new
Rafter Set.
7. Unlatch the bottom of the Arm from the Wall Bracket on the house. See
Figure 4
.
House
Roller Bar resting on one
or two chairs as needed
Figure 1
Figure
4
Figure
3
Roller Assembly
Arm
and
Rafter
Flat-head
Bolt
Figure 2
1
/4” nut and bolt
