Page 12
STEP 15 and 16: Attach the table WOOD SUPPORT BRACKETS to the BENT LEGS and attach the WOOD
TABLE to the WOOD SUPPORT BRACKETS. Tighten the hardware now.
STEP 17: Place the CANOPY RODS into the ADJUSTABLE CANOPY SUPPORT ASSEMBLY. They will
just sit in the tubes until the CANOPY is put on the swing.
NOTE: If the CANOPY is too cold it will not stretch enough to get it over the last CANOPY ROD. Place the
CANOPY in a warm room until it warms up enough to stretch over the last CANOPY ROD.
STEP 18: The CANOPY is a rectangular piece of fabric with pocketed corners. Begin by laying the CANOPY on
top of the CANOPY RODS. Then slide one of the pocketed corners of the CANOPY onto one of the CANOPY
RODS. Continue around the CANOPY until the last corner. Getting the last corner onto the CANOPY ROD
requires stretching the fabric by pulling the CANOPY fabric towards the end of the CANOPY ROD and slightly
down. Continue stretching the CANOPY towards the end of the CANOPY ROD until it slides into the corner
pocket of the CANOPY.
Summary of Contents for 422L
Page 5: ...Page 4 EXPLODED DIAGRAM...
Page 6: ...Page 5 TOOL AND HARDWARE DIAGRAM...
Page 16: ...Page 15...
