ZIPPIE VOYAGE
IX. DEALER SERVICE & ADJUSTMENT
5
1
5
1
5
2
Harness Adjustment (Moderate Seating)
a.
Place the child in the seating system and fasten the pelvic positioning belt.
b.
Position the child's hips and tighten the belt to the proper position.
c.
Unlock the two lower cam locks (L) and the two upper cam locks (U).
d.
First, adjust the lower straps to keep the harness from riding up on the child's torso and
lock lower cams (L).
e.
Then, adjust the upper straps making sure there is enough room around the
child's neck for easy breathing and eating, and lock upper cams (U).
U
L
5
2
245797 Rev. A
24
ANTERIOR TRUNK SUPPORT (Continued)
P. LATERAL TRUNK SUPPORTS
(ADVANCED SEATING)
Assembly to the Seating Shell
a.
From behind your unit, unzip the back upholstery and remove the back pad to expose back shell.
b.
Insert screws and washers (A) from the rear of the shell through the adjustment slots.
c.
Thread the bolts into the lateral nut plate clamping the lateral mounting plate to the backshell.
d.
Tighten the screws.
a.
b.
Unzip the rear cover to access the adjustment screws.
Loosen
(do not remove) the mounting screws (B) from the front of the shell enough to gain
horizontal adjustment of the laterals. Adjust the lateral brackets for width bringing the lateral
assembly including the pads to the proper position. If more hori-zontal adjustment is needed,
you can also adjust the swing-away bracket.
c. Tighten the mounting screws to hold the adjustment.
d. To gain vertical adjustment of the laterals, loosen screws (A) from the rear of the back-shell,
and move the laterals up or down to the proper position, and tighten the screws.
5
3
Lateral Height and Width Adjustments
NOTE - The following adjustments may be able to be accomplished with the child present in the
seating system.
5
3
5
3
A
B
C
5
4
D
E
Lateral Length and Rotation Adjustments
a.
Slide the lateral cover and foam forward or remove to expose adjustment screws.
b.
Loosen screws (
D
) and move lateral to proper length, you can also add a slight rotation by
twisting the lateral slightly. Be sure to make the same adjustment on the
other side.
c.
Tighten screws and replace the foam and cover.
Lateral Swing-Away Operation
a. Depress the silver lever (C) allowing the lateral to swing inwards or outwards. This is
useful for storage or helping a child into or out of the seating system.
NOTE -
The laterals lock into the adjusted preset position which can be angle adjusted by
following steps in the next section “Lateral Angle Adjustment”.
Lateral Angle Adjustment
a.
Lock the lateral by rotating inwards.
b.
Loosen the angle lock screw (
E
) as shown at the lateral hinge point.
c.
Adjust the lateral angle to the proper position and tighten.
5
4
5
4
5
3