43
ENGLISH
Argon
2
Rev.C
Fig. 4.43
The lap belt should be fixed so that the belt sits at an
angle of 45 degrees across the users pelvis. The user
should be upright and be as far back as possible in the
seat when correctly adjusted. The lap belt should not
allow the user to slip down in the seat.
(Fig. 4.44)
To fasten buckle:
Firmly push male buckle
into female buckle.
To release belt:
Press exposed sides of
male buckle and push
towards centre whilst gently
pulling apart.
WARNING !
•
If in doubt about the use and operation of the lap belt
then ask your healthcare professional, wheelchair
dealer, carer or attendant for assistance.
•
The lap belt must only be fitted by an approved
Sunrise Medical dealer / agent.
•
The lap belt should only be adjusted by a
professional, or a Sunrise Medical approved dealer /
agent.
•
The lap belt must be checked on a daily basis to
ensure it is adjusted correctly and free from any
obstruction or adverse wear.
•
Sunrise Medical does not encourage the
transportation of any person in a vehicle using this
lap belt as a method of restraint.
Please see Sunrise Medical transit booklet for
further advice on transportation.
Maintenance:
Check lap belt, and securing components, at regular
intervals for any sign of frays or damage. Replace if
necessary.
WARNING
The lap belt should be adjusted to suit the end user as
detailed above. Sunrise Medical recommend that the
length and fit of the belt be checked on a regular basis to
reduce the risk of the end user inadvertently re-adjusting
the belt to an excessive length.
Fig. 4.44
5.0 Tyres and Mounting
Solid rubber tyres are standard.
With pneumatic tyres always make sure that the tyres
have the correct air pressure, as otherwise the
performance of the wheelchair may be affected. If the tyre
pressure is too low, rolling resistance will increase,
requiring more effort to move the chair forward. Low tyre
pressure also has a negative impact on manoeuvrability. If
the tyre pressure is too high, the tyre could burst. The
correct pressure for a given tyre is printed on the surface
of the tyre itself.
Tyres are mounted the same way as an ordinary bicycle
tyre. Before installing a new inner tube, you should always
make sure that the base of the rim and the interior of the
tyre are free of foreign objects. Check the pressure after
mounting or repairing a tyre. It is critical to your safety and
to the wheelchair’s performance that regulation air
pressure be maintained and that tyres be in good
condition.
6.0 Maintenance and care
• Check the tyre pressure every 4 weeks. Check all tyres
for wear and damage.
• Check the brakes approximately every 4 weeks to make
sure that they are working properly and are easy to use.
• Change tyres as you would an ordinary bicycle tyre.
• All of the joints that are critical to using your wheelchair
safely are self-locking nuts. Please check every three
months to make sure that all bolts are secure (see the
section on torque). Safety nuts should only be used once
and should be replaced after use.
• Please use only mild household cleansers when your
wheelchair is dirty. Use only soap and water when
cleaning the seat upholstery.
Anteria Lateral Support
(Lap belt)
