I. ARMREST
Sunrise medical offers several different types of armrests. Fixed, swing-away, and Flip-back
armrests. Flip-back armrests can be detached or can flip back to allow lateral transfers. They are
height adjustable (1"
(25.4mm)
increments) by
pushing the button
(1)
and moving the armrest
pad (
2
) up or down to the desired height.
1.
Height Adjustment
a.
Push the button (1) to release the armrest pad (2).
b.
Slide armpad up or down to desired height.
c.
Push down to return to locked position.
2.
Flipping armrest back
(also applies to desk sideguard)
a.
To flip back, grasp the unlocking lever (3) and pull up on the Armrest.
3.
Replacing Armrest
(also applies to desk sideguard)
a.
Slide armrest back into receiver until you hear it click into place.
b.
Make sure that the unlocking lever (3) returns to the locked position.
17
VIII. USE AND MAINTENANCE
XENON2
16
WARNING
Armrest should not be used for lifting or carrying the wheelchair.
Always check that the armrests are correctly engaged.
There is a risk of trapping fingers when adjusting the armrests.
G
16
WARNING
If the anti-tip tubes are not fitted, or have been fitted incorrectly, there is a risk of tipping over and of
injury.
J. PADDED SWING-AWAY ARMRESTS
1.
Installation
a. The armrest height is determined by the adjustment bolt (A) position.
b. Slide the armrest into the receiver tube (B) on rear of frame until the adjustment bolt is
securely seated (locked) in the receiver tube slot.
2.
Swinging Away
a. Lift armrest out of the locked position and rotate to the side
3.
Removing Armrest
a. Pull armrest straight out of the receiver.
19
19
2
1
3
18
17
18
A
B
15
ANTI-TIPS (continued)
3.
Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles, or climbing curbs.
a.
Press the rear anti-tip tube release pin.
b.
Hold pin in and turn anti-tip tube up.
c.
Release pin, and make sure the anti-tip is locked in place.
d.
Repeat these steps with second anti-tip tube.
4.
Swing-Away Anti-Tip
Push down on the top of the anti-tip tube, (G), to bring them into position, Fig 1
6
. A 1-1/2" to
2"
(3
8
mm to
51mm
)
gap should be maintained between the anti tip wheels and the ground.
The anti-tips can also be swung into a forwards position.
245243 Rev. D
Summary of Contents for Quickie XENON2
Page 31: ...NOTES XENON2 31 245243 Rev D...
