30
31
930356 Rev. B
930356 Rev. B
I. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed
by Sunrise. A cable trigger mechanism
positively locks the chair in place from
0
o
to 45
o
.
1. Cable Adjustment
a. Loosen the jam nut by turning it
clockwise.
b. Turn the cable adjuster until slack
is removed from cable.
c. Tighten jam nut.
Important Note:
Gas Cylinder. Gas charged
cylinder. It is non-repairable. Call an authorized
representative if it is not working properly.
DO NOT ATTEMPT TO REMOVE FROM
WHEELCHAIR.
J. DUAL TRIGGER RECLINING
MECHANISM
The dual trigger reclining mechanism is
installed by Sunrise.
1. To Recline or Raise Backrest
a. Depress both triggers (a) at the same
time. Releasing the triggers positively
locks the backrest in place within its
90
o
range.
b. To secure backrest position, insert the
locking pin (b) into the trigger holder.
Always lock the dual trigger reclining
mechanism securely in place after posi-
tioning the backrest.
I X .
S E T U P & A D J U S T M E N T
a
b
I X .
S E T U P & A D J U S T M E N T
H. ANTI-TIP TUBES
Anti-tip tubes are recommended for all
wheelchairs.
Note:
Use a torque setting of 100 in.-lbs. when
setting up the anti-tip tubes.
1. Inserting Anti-Tip Tubes Into
Receiver
a. Press the rear anti-tip release lever
(c) on the anti-tip tube so that both
release pins are drawn inside.
b. Insert into the anti-tip tube receiver (d).
c. Turn the anti-tip tube down until
release pin is through the receiver
mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Tube Wheel
(avail able with 20” rear wheels only)
The anti-tip tube wheels may have to be
raised or lowered to achieve proper clear-
ance 1 1/2” to 2”.
a. Press the anti-tip wheel release button
so that both release pins are drawn
inside (e).
b. Raise or lower to one of the three
predrilled holes.
c. Release button.
d. Adjust the second anti-tip tube wheel
the same way.
Important Note:
Both wheels should be at
exactly the same height.
c
d
e
