R
G
B
W
S-
S+
B-
B+
W+
P-
P+
1
2
3
4
5
6
7
8
RF RGBW Remote Controller
09.289T8.04168
Indicator: indicate the state of
remote control
Click to switch CW,
NW, WW mixed by RGB
4.5V(3xAAA battery)
Function introduction
Important:
Read All Instructions Prior to Installation
Output
RF signal
Operation Frequency
869.5/916.5/434MHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
131.4x43.8x24.3mm
Front side
Back side
•
High sensitive & high stable, fast & precise color control.
• Enable to control 8 zones separately.
• 10 changing modes.
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
Safety & Warnings
Power Supply
4.5V(3xAAA battery)
R
G
B
W
S-
S+
B-
B+
Touch color wheel, touch to
choose RGB color tone
8 zones
Click to choose the zone/zones,
Press and hold down to turn on/off
corresponding zone
Press and hold down to increase
light intensity of RGB
Press and hold down to
decrease light intensity of RGB
Speed up under dynamic mode
Speed down under dynamic mode
R/G/B/W 4 channels
.
Click to switch on/off each channel;
Press and hold down to increase/
decrease light intensity of each
channel
W+
P-
P+
1
2
3
4
5
6
7
8
Built-in 10 dynamic modes,
P- is previous mode,P+ is next mode.
•
This device contains AAA batteries that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Pair with RF receiver(Method 1)
Step 4:
Choose and click a zone number(
e.g.
zone
4
)
Step 3:
Click the “
Learning Key
” button on RF receiver or re-power on the receiver
three times continuously to set it into pairing status
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 5:
Touch the color wheel, LED lights connected with the RF receiver flicker
once means the receiver is paired with zone 4 successfully.
Step 2:
Click
ON/OFF
button to activate the remote
Pair with RF receiver(Method 2)
Step 4:
Choose and click a zone number(
e.g.
zone
4
) twice, then press and hold it
continuously and quickly within 10 seconds, LED lights connected with the RF receiver
flicker once means the receiver is paired with zone 4 successfully.
Step 3:
Power off and power on the receiver
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 2:
Click
ON/OFF
button to activate the remote
R
G
B
W
S-
S+
B-
B+
W+
P-
P+
1
2
3
4
5
6
7
8
