Sunred HEXAGONAL GLASS HEXB, Manual

Page: 11 / 77

www.sunred.nl
CLEANING AND MAINTENANCE:
- To enjoy outstanding performance of your heater for years make sure to perform the following maintenance
activities on a regular basis:
-
Keep exterior surfaces clean.
- Use warm soapy water for cleaning. Never use flammable, corrosive or abrasive cleaners.
-
While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all time. If the gas
control is exposed to water in any way, do NOT try to use it. It must be replaced.
-
After a long break from operation, the unit should be inspected for spiders, spider webs or other insects
-
Air flow must be unobstructed. Keep controls, burner and circulating air passageways clean. Signs of possible
blockage include:
o
Gas dour with extreme yellow tipping of flame.
o
Heater does NOT reach the desired temperature.
o
Heater glow is excessively uneven.
- Heater makes popping noises.
- Spider and insects can nest in burner or orifices. This dangerous condition can damage heater and render it unsafe
for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller
particles.
-
Carbon deposits may create a fire hazard. Clean reflector and glass tube inside with soapy water if any carbon
develops. Always be careful when cleaning the glass tube.
STORAGE:
Between uses:
-
Turn the control knob to “OFF” position.
-
Turn LPG cylinder to “OFF” position.
- Store heater upright in an area sheltered away foam weather conditions (such as rain, sleet, hail, snow)
-
If desired, cover heater to protect exterior surfaces and to help prevent dust and debris collecting in air passages.
During periods of extended inactivity or when transporting:
-
Turn the control to “OFF” position.
- Disconnect LPG cylinder and move to a secure, well-ventilated location outdoors. DO NOT store in a location that
will exceed 50 degrees C.
-
Store heater upright in an area sheltered away from weather conditions (such as rain, sleet, hail, snow)
- If desired, cover heater to protect exterior surfaces and to help prevent dust and debris collecting in air passages.
WARNING
-
DO NOT touch or move heater for at least 45 minutes after use.
-
Allow all burner elements to cool before touching
NOTE
-
In a salt-air environment (such as near an Ocean) corrosion occurs more quickly than normal
- Frequently check for corroded areas and repair them promptly.
- Wait until the heater is cooled down before covering.