OPERATION AND STORAGE
TO TURN ON THE HEATER
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the variable control knob to PILOT position (counter-clockwise 90º).
3. Press down the variable control knob and hold for 30 seconds. While holding down the variable control knob,
press the igniter button several times until the pilot flame lights. Release the variable control knob after the pilot
flame lights.
Note:
If a new tank has just been connected, please allow at least one minute for the air in the gas pipeline to purge out
through the pilot hole.
When lighting the pilot flame make sure that the variable control knob is continuously pressed down while
If the pilot flame does not light or it goes out, repeat step 3.
4. After the pilot flame lights, turn the variable control knob to maximum position and leave it there for 5 minutes or
more before turning the knob to desired temperature position.
Warning
：
check that no broken on the glass is found before operation.
TO TURN OFF THE HEATER
1.Turn the variable control knob to PILOT position.
2.Press and turn the variable control knob to OFF position.
3.Turn off the valve on the gas supply cylinder completely.
Storage
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure regulator and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage, have it changed by your gas
dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
Igniter
Variable control knob
Off: the heater stop work
Hi: maximum temperature position
Lo: minimum temperature position
