1
2
3
Adjusting the Umbrella Up & Down
Using the crank handle (2), raise the umbrella to desired
height. Turn the crank handle (2) clockwise to open the
umbrella.
Adjusting The Umbrella Tilt
Hold the umbrella pole (1) above the tilt button, and
press the tilt button (2) inward.
With the tilt button pushed inward, move the
umbrella to the desired position, then release the
button to lock in place.
CAUTION: The Umbrella ribs may compress during
shipping. Before opening the umbrella turn it upside
down and shake it gently to sperate ribs.
!
CAUTION: Securely fasten the umbrella to an
appropriately sized umbrella base (not included). Do
not install into the fround. Not intended for permanant
installation or use.
!
Take out the bottom pole (2) and the umbrella body(1) from
the bag
Twist the lower umbrella pole (2) into umbrella (3)
If your model shipped with the solar panel (4) packed
separately (not attached to the umbrella), match the
electronic connector from the solar panel with the
electronic connector located at the top of the umbrella (5).
Then insert and twist the solar panel into the top cap to
lock.
Place the umbrella upright in a heavy weighted stand (not
included), and table capable of firmly
securing the Umbrella.
Care Instructions
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation
Caution: The user is cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
If power exceeds the limit and the distance
（
Over 20cm distance in actual use between the device
and user
)
is compliant with the requirement
This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this transmitter must be installed and operated to provide a
separation distance of at least 20 cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter. Installers must ensure that 20cm separation
distance will be maintained between the device (excluding its handset) and users.
Summary of Contents for 801040
Page 1: ......
