文件编号
Document No.
：
SP/WI-JS-010
- 19 -
我们建议你为你的太阳系统投保以防止自然灾害
(
例如雷击
)
。
（
21
）
Sunpro power modules are certified to be installed and operated in safety level II at voltages lower
than 1500Vdc.This maximum voltage should not be exceeded at any time and, as the voltage of the module
increases, above data sheet values, at operating temperatures below 25 ° C, then these need to be taken into
account when designing a PV system.
Sunpro Power
组件经认证
,
可在低于
1500Vdc
的电压下安装和操作安全级别
II
。 在任何时候都不应超过此最大
电压，并且随着组件电压的增加，高于数据表值，工作温度低于
25°C
，则在设计
PV
系统时需要考虑这些。
（
22
）
Under normal conditions, a solar photovoltaic module is likely to produce more current and /or voltage
than reported under standard test conditions. Accordingly, the value of Isc marked on this module should be
multiplied by a factor of 1.25 when determining the conductor current ratings, fuse sizes and size of controls
connected to the SPV output.
在正常情况下，太阳能光伏组件可能产生比标准测试条件下报告的更多的电流和
/
或电压。因此，当决定导体电
流额定值、熔断器尺寸和连接到
SPV
输出的控制的尺寸时，在这个模块上标记的
Isc
值应乘以
1.25
的因子。
（
23
）
Do not install modules in a location where they will be immersed in or continually exposed to water.
请勿将组件安装在会浸入或持续暴露于水中的位置。
5.2
、
ENVIRONMENT CONDITIONS AND SITE SELECTION
环境条件与安装地址选择
YuHuan Sunpro Solar module should be installed in the following environmental conditions.
适用于玉环尚博太阳能光伏组件安装的环境条件如下：
Table 5-1 operation condition
表
5-1
组件操作和工作环境
NO
序号
Environmental conditions
环境条件
Range
范围
1
Recommended Working temperature
推荐工作环境温度
-40℃～+40℃
2
Storage temperature
存储温度
-20℃～+50℃
3
Humidity
湿度
＜85RH%
Remarks:
The working environment temperature is the monthly average maximum temperature and
minimum temperature of the installation site. The mechanical load bearing capacity of the Solar PV modules
determined based on the installation method. Mechanical Load Pressure: The design pressure is 3600
(front)/1600 (back) and the safety factor is 1.5.
备注：该工作环境温度为安装地点月平均最高温度和最低温度。太阳能光伏组件所能承受的机械载荷是由安装
方式来决定的，机械负载压力：设计压力为
3600
（前）
/1600
（后），安全系数为
1.5
。
Notes:
- The mechanical load bearing is dependent upon the mounting methods used and failure to follow the
instructions of this manual may result in different capabilities to withstand snow and wind loads. The system
installer must ensure that the installation methods used meet these requirements and any local codes and
regulations.
注释：
机械承重取决于所使用的安装方法，如果不遵循本手册的说明，可能会导致承受雪和风载荷的能力不同。 系统
