6200PG
with compact pistol grip ball head
Sunpak Lifetime Limited Warranty
This Sunpak product has been carefully manufactured, accu-
rately adjusted, inspected and thoroughly tested before shipment
to assure you of the highest quality.
Should this product require service, we will repair or replace, at
our option, any part or the product itself, which our examination
shows to be defective in material or workmanship. This warranty
does not apply to wear and tear associated with the normal use
of the product. This warranty is non-transferable.
Repairs will be made to the product at no charge, under the
terms of the warranty as stated above, only when accompanied
by a dated and itemized bill of sale and nominal handling charge.
Be certain to follow all assembly and/or operating instructions
with this product. This warranty is not valid if the product has
been misused or damaged in any way that is beyond our control
or through normal wear and tear associated with use. This war-
ranty applies only to the product and we are not responsible in
any way for losses, damages or any inconvenience caused by
equipment failure.
Some states do not allow the exclusion or limitation of conse-
quential damages, so the above limitation or exclusion may not
apply to you. This warranty gives you specific legal rights and
you may have other rights which may vary from state to state.
Should service be required, the product should be carefully
packed (in the original packaging if possible ) and sent, prepaid
and insured, along with a check or money order for $9.95
(shipping and handling), to the address listed below. A note
briefly describing the nature of the defect should also be en-
closed to expedite handling.
Proof of purchase and payment for shipping and handling
must be included for warranty repairs.
OWNER’S RECORD
Please complete this section and retain with your original
bill of sale for your records.
Model:
Sunpak 6200PG Tripod
Purchase Date:
___________________________________
Address:
___________________________________
City:
__________________________________
State:
___________________
Zip Code:
___________________
Sunpak
ToCAD America Inc.
53 Green Pond Road
Rockaway, NJ 07866
tocad.com
Precautions
Insure that all levers, handles, knobs and leg
locks are properly tightened, and that all three
legs are fully angled opened before use.
Do not mount any camera directly onto the
head mount screw located on the top of the
tripod’s center column. The screw may be
longer than the tripod socket in your
camera, and could possibly cause damage.
Do not carry or transport the tripod with the
camera equipment attached (as example but
not limited to: over your shoulder or
cradled in your arms).
Do not Oil or Grease any part of the tripod.
Do not use any solvents or thinners to clean
your tripod. Use mild detergent and wipe dry
with a soft, lint-free cloth only.
Do not store or expose your tripod to
excessive heat or cold or use close to any
flame or fire.
Do not exceed the load limit for this product.
Cat. no. 620-620-CPG
Opening and Closing
Your Sunpak 6200PG tripod is equipped with metal
Center Leg Braces for maximum stability and strength.
Extend the leg
sections to
the desired
length and
secure each
section using
the Leg
Locks. Pull
each leg out-
ward until all
three braces
are fully ex-
tended and
gently press
down on any
brace until it
stops and secure with the Lock Knob.
When closing the tripod, gently push up on any Leg
Brace.
Sunpak
