3
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
EU Compliance Statement
Hereby
，
Sunonwealth Electric Machine Industry Co.,Ltd. declares that the radio equipment
type[S-RF1/S-RF1-R designation of type of RE] is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following internet
address:www.sunon.com/tw/
This Equipment is required to have a CE Mark on the Label which means that the equipment has been
tested to the following Directives and Standards:This equipment has been tested to the requirements
for the CE Mark as required by Radio Equipment Directive 2014/30/EU as indicated in European
Standard EN 300 and EN 301 and the EMC Directive 2014/30/EU as indicated in European Standrad EN
55014.
The operating frequencies and maximum transmission power levels for wireless devices operated in
the EU are listed below:
Summary of Contents for S-RF1
Page 1: ...S RF1 Remote Control Operating Instructions...
Page 2: ......
