x2
x2
ASSEMBLY
Page 2 / 4
5
1. Ensuring the shorter side of the legs are in the front, align the
mounting holes on Right Leg Base (C), Left Leg Base (D) and
Bottom Support (B).
2. Secure the base and bottom support using two Bolts (E), two
Washers (G) and two Nuts (H). Tighten hardware using Hex
Key (L) and Back Nut Tap Spanner with Pivot Pin (M).
3. Place Top Support (A) onto Bottom Support (B) and align the
mounting holes.
4. Secure the support tubes with Bolt (F) and securely tighten
using Hex Key (L).
5. Attach Carabiner (I) or Hook (J) to Top Supports (A). See
Hanging Your Hammock Chair
, page 3.
Carefully read all assembly steps, care instructions,
and safety information before using this product.
Save these instructions for future reference.
Assemble components on a soft, clean surface to avoid scratching/damaging the finish.
When choosing a location for your hammock stand, select a smooth, level surface.
Do not install on dangerous terrain or objects such as slopes, on rocks, or in bodies of water.
Tip:
Always fully insert the hex key into the designated
notch of the bolt.
If the hex key is
not fully inside
the notch, the hex
key could slip out,
causing damage to
the bolt head.
Repeated hex key slipping will cause the notch to
become rounded, making it difficult or impossible to
tighten the bolt with the hex key.
IMPORTANT:
The shorter side of the legs
install on the front of the stand; the long side
of the legs extend behind the stand.
10/2021