ASSEMBLY
Read carefully and understand assembly before beginning.
Do not fully tighten bolts all until all components have been loosely assembled.
Page 2 / 3
STEP 1
A:
1
D:
2
F:
4
Do not fully tighten any bolts until after Step 3 is complete.
STEP 2
B:
2
C:
2
E:
2
G:
8
H:
8
• Ensure the notches for the lower shelf on Side Panel (D) are facing the same direction.
• Align Shelf Panel (A) with the tops of Side Panels (D) and loosely secure by hand-tightening four M6x45 Bolts (F).
• Insert two Barrel Nuts (I) into Bottom Shelf Support (B) and Top Shelf Support (C). Use the Barrel Nut Driver to align
the opening of the barrel nut with the pre-drilled hole below the peg on the shelf supports.
• Ensuring Top Shelf Support (C) is on top, align the pegs and holes of Top Shelf Support (C) and Bottom Shelf
Support (B) with the side panel and Front Leg (E), then loosely secure by hand-tightening four M6x50 Bolts (G),
ensuring the bolts thread into the barrel nuts.
• Repeat the previous step on the opposite side of the unit.
07/2020
89707
Do not fully tighten any bolts until after Step 3 is complete.
