OPTIONAL CORD PROTECTORS
1.
Tape the cord channel against the wall where the cord
will go down the wall.
2.
Mark the top and bottom hole with a pencil. Remove the
tape and cord channel from the wall.
3.
Drill starter holes (1/4 inch or 6mm) on the pencil marks.
4.
Gently hammer two wall anchors into the starter holes.
5.
Align the cord channel with the wall anchors and secure
it using two wall screws.
6.
Put the cord into the Cord Channel. Cover the Channel
with one or both cords cover.
TROUBLESHOOTING
•
Ensure that the pump is fully submerged and add water if necessary.
•
Check the pump and tubing for obstructions.
•
If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few moments and plug it back
in; the pump may have air trapped inside it which can prevent water from circulating properly.
•
Adjust the flow control on the body of the pump to achieve the desired flow rate.
•
If water is not flowing evenly, it may be due to the porous nature of the slate material. Moisten the entire slate surface beneath the downspout
to even out water flow.
•
If the light is not working, ensure the cable is fully connected and the seal is adequately tightened (do not over-tighten).
•
Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
USE & CARE
•
FOR INDOOR USE ONLY.
•
Keep fountain out of reach of children and pets.
•
Keep power cord away from all heat sources. Do not place electrical cords in areas with high temperatures.
•
Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn out the motor.
•
Only use water in this fountain; distilled water is recommended to prevent mineral buildup.
•
Periodically change the water to reduce scale and buildup — clean components regularly for optimal performance and appearance.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use abrasive materials to scrub the fountain.
•
Always shut off the power supply before cleaning and maintaining the fountain and the pump.
•
Take care when handling the pump; only pick it up by the body of the pump, never by the power cord.
Any modification or failure to follow the recommended care will void the product warranty.
IMPORTANT INFORMATION
SPQ50048
Page 2 / 2
01/2020
OPTIONAL WALL-MOUNT:
1.
Tape the bottom of the wall-mount bracket on the wall
17.5 inches above where the bottom of the fountain will
rest on the wall. Check to make sure the bracket is level.
2.
Mark the holes in the bracket with a pencil. Remove the
tape and bracket from the wall.
3.
Drill starter holes (1/4 inch or 6mm) on the pencil marks.
4.
Gently hammer three wall anchors into the starter holes.
5.
Align the wall-mount bracket with the wall anchors and
secure it using three wall screws.
6.
Ensuring the preinstalled bracket on the fountain is
centered over the wall-mount bracket, carefully lower
the fountain onto the wall-mount bracket. Check to make
sure the pump power cord is within the groove on the
backside of the fountain basin.
K
I
J
WARNING!
Manufacturer and seller expressly disclaim any and all liability from personal injury, property damage
or loss, whether direct or indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
J
M
I
L
Before wall-mounting, ensure the wall can support the weight of the fountain while it is full of water.
