Note
: When first used, there may be air in the pump.
It may take several minutes for the air to escape and water begins to flow.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin if
necessary.
• Check to make sure the power outlet is working; if in doubt about electrical
connections, consult a certified electrician.
• Check the pump and tubing for obstructions.
• Check the flow control on the body of the pump as it may need to be adjusted
to achieve the desired flow rate.
• If the light is not working, ensure the cables are fully connected, and the seal
is adequately tightened (do not over-tighten).
• If water is not flowing within several moments of the fountain being plugged in,
unplug the power supply for a few moments and plug it back in; the pump may
have air bubbles in the filter which can prevent water from circulating properly.
IMPORTANT INFORMATION
USE & CARE
• For indoor use only.
• Check the water level frequently to ensure the pump remains fully submerged;
never allow the pump to run dry as it will burn out the motor.
• Only use water in this fountain; distilled water is recommended to prevent
mineral buildup.
• Periodically change the water to keep the water, fountain and pump clean.
Remove scale and build-up regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use anything abrasive to scrub the fountain.
• Always shut off the power supply before cleaning and maintaining the fountain
and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the pump,
never the power cord.
Any modification or failure to follow the recommended care
will void the product warranty.
3
2
Assemble components of this fountain on a soft, clean surface to avoid scratching or damaging the finish.
ASSEMBLY:
1. Connect the electric submersible pump to the tubing that is inside
the fountain.
2. Connect the shorter pump cable to the LED light and place the
light in the basin of the fountain.
3. Connect the longer pump cable to the AC adapter.
4. Fill the fountain with enough water to keep the pump fully
submerged during operation.
5. Place the splash screen onto the fountain basin.
6. Plug the power cord into a properly grounded GFCI outlet.
1
2
1
3
4
5
6
