02/2019
AMP-P022C
Page 3 / 3
Any modification of this product or failure to follow the recommended care, safety and warning statements will void the product warranty.
7. TROUBLESHOOTING
Pump is not operating even though the solar panel is in full sunlight.
► Pump is submersed – ensure the pump is fully submersed in water as it will not operate if it is not.
► Cable connection secure – ensure the pump cable is securely attached to the solar panel.
► Solar panel turned on – check to make sure the solar panel is powered on.
► Impeller may be blocked – disassemble the pump as shown above. Use a small brush or stream of water to remove any debris.
► LED light is not turning on during the day – the kit is designed so the light only works at night and only when the "battery powered" mode
is turned on.
Pump is operating but there is little or no water running through the fountainhead.
► Clear debris – check to ensure debris is not blocking the front of the pump.
► Buildup of sediment or scale – check the pump, filter, tubes and fountainheads for blockages. Clear loose blockages by hand and clean
pump components. Fountain cleaning products are recommended for cleaning fountain components;
do not use bleach
to clean this product
as using bleach will invalidate the product warranty.
Battery Powered mode is not working as I thought it should.
► Set the mode – check to see if the red indicator light is steady on.
► Ambient light – if the red indicator light is on, the solar panel may be receiving too much ambient light for the "battery powered" mode to
operate. If the ambient light is originating from sources such as street or flood lights, the panel may need to be moved.
► Red light is blinking – if the red light is blinking, the battery power is low and the fountain will soon turn off. The batteries will need to be
recharged before this mode can be used again.
► Boost Charge – unplug the pump and light cables and allow the battery pack to recharge for 2 or 3 sunny days. Avoid testing the battery
powered mode during a boost charge as this will diminish the battery power.
► Replace – if a boost charge does not revive the batteries, replace the batteries with compatible batteries.
• Altering of this product or changing components is prohibited.
•
Do not connect the pump to any AC voltage power; it is intended ONLY for DC voltage power.
•
Do not pump with flammable liquids.
•
Do not use pump with water above 50
°
C (122
°
F).
•
During freezing weather, dry and store all components of the kit.
•
Do not strike the solar panel.
•
Do not lift the pump by the power cable.
• Operate the pump in freshwater only.
•
Do not use bleach or corrosive chemicals to clean any components of the unit.
SAFETY & WARNING STATEMENTS
Solar Panel
2.5W
Pump Operation Voltage
6V-9V DC
Max. Water Lift
1.2 meters
Max. Flow Rate
250 L/H
LED Light Operation Voltage
6V DC
Rechargeable Battery
AA Ni-MH 1500mAh
8. TECHNICAL DATA
