1. Test the power outlet to make sure it is providing 220 Volts AC electricity. If this is
not the case, correct the issue before moving for ward to the next step.
2. Install the emergency lighting unit in an area where emergency illumination is
desired. Perform inspection checks to make sure the unit is installed properly to
prevent accidents such as the unit coming loose and falling.
3. Plug the unit into a power outlet with 220 Volts AC 50Hz electricity.
4. Check that the "AC" LED light is on to indicate that the unit is receiving a 220Vac
power supply.
5. Check the “CHARGE” or “FULL” LED light to see the status of the battery.
The “CHARGE” LED will be on when the battery is charging and the “FULL” LED will
be on when the battery is fully charged.
6. Check if the TEST switch is working. When pressed the sign should illuminate
and the “AC” LED should turn off.
7. The ON and OFF switches are used to turn the sign on and off when the
emergency exit sign is not plugged in.
1. The unit should be installed indoor and away from moisture, humidity or
direct sunlight.
2. The unit should be kept within room temperature of around 25 degree Celsius.
3. The battery should be immediately charged after each use to prevent a shorten
battery life.
Installation and Operation
Important Note on Using the Unit