OPERATING YOUR APPLIANCE
* Firstly remove the dust reservoir by
holding the handle.
* Open the filter lid then fill the dust
reservoir with tap water considering the
max level. Required quantity is 800 cc
(0,8 lt) water. Be careful, the water
never
exceeds the max level.
* Close the upper cover, bu sure that the
filter system is on their place. Replace the
dust reservoir on its place.
* Attach the hose to the hose inlet socket.
* Attach the suitable accessory according to
place, which you will clean. Adjust the
telescopic tube for the appropriate length.
* Pull out the electric cable and adjust
suitable length and plug your appliance.
* Start up your appliance by pressing ON-OFF button.
* There are 4 suction power level on your appliance. You can adjust
suction power of your appliance by pushing the + or - buttons
according to place, which you clean.
* It is sufficient to press again the on/off button to finish the vacuum cleaning process.
WARNING:
* Because your vacuum cleaner is not wet/dry type but water filtered
vacuum cleaner, do not use it to absorb water or any other liquid.
* Never operate your vacuum cleaner without putting water.
* You can use your appliance to vacuum the dust and a little liquids.
If the dirt, collected in the reservoir, reaches the maximum level,
security float will stop the suction automatically and sound will
occur. Switch off your vacuum cleaner and wait 15 seconds, then operate your appliance
again.
CARE AND CLEANING:
*
Always
unplug your mains cable from the wall socket, before attempting any maintenance
or care process.
* In order to obtain maximum results from your product, discharge dust reservoir after each
usage and rinse dust reservoir with cold water. Make sure that reservoir is completely dry
before attaching it into its place again.
Summary of Contents for AT-152
Page 8: ......