EXERCISE COMPUTER
KEY FUNCTIONS:
MODE:
Press the red MODE button to select function (Time,
Rep/Min, Count, Calorie and Scan).
OPERATIONAL FUNCTIONS:
1.
AUTO ON/OFF:
If the stepper is put into motion or the MODE button is pressed, the meter
will activate and will remain active during use. If there is no activities for approximately 4
minutes, the meter will turn off automatically.
2.
RESET:
The meter can be reset by pressing and holding the MODE button for three
seconds. Removing the batteries will also reset
the mete
r and return all
function settings
back to zero.
3.
MODE:
To select the LOCK MODE setting, press the MODE key when the pointer is on the
function you wish to lock. Once locked, only the selected function will be displayed.
FUNCTIONS:
TIME:
Counts total time
of an exercise from start to finish.
CALORIES:
Counts total calories
burned during an exercise from start to finish.
COUNT:
Automatically accumulates
step counts
taken during sessions. Meter counts 1 step
for every step on each foot
.
REPS/MIN:
Displays
count of steps
per minute.
SCAN:
Press the
MODE button until the arrow points to SCAN
. Once on SCAN, the display
will scan through each of the functions in sequence.
NOTE:
1.
If you have an inaccurate reading on the monitor, replace the battery immediately.
2.
Use
(1) LR44, 1.5V battery
.
3.
The monitor is auto-powered. It turns on when exercise begins, and it turns off when there
is no movement made in 4 minutes.
4.
All functions will stop calculating when STOP appears in the upper left corner of the
display monitor. This occurs when there is no signal for a period of 4 seconds. Once the
exercise begins, the meter will start recalculating and the STOP will disappear.
NOTE:
An additional LR44 battery is included with your manual. Replace the battery if your new
meter is not functioning due to battery drainage. See next page for instructions on changing
your battery.
6
COUNT
REPS
/MIN
TIME
SCAN
CAL
Summary of Contents for P8000
Page 3: ...2 EXPLODED DIAGRAM ...
Page 9: ......
