●
If only red LEDs on the Battery Gauge lights, the batteries are
nearly running out of charge. You should recharge the batteries as
soon as possible. We recommend charging the battery for 8-14 hours
●
Check the rear wheel inflatable situation, if the tire deformed serious
when riding , it should be inflated.
●
The frame surface has been sprayed with a clear sealant coating. You
can apply a light coat of car wax to make the surface keep a high gloss.
●
Check all cable connections. Make ensure they are fastened and are
not corroded. The battery must be placed in the battery area, flat, the
battery plug inward, relative display, refer to the correct connection on
the main frame label.
●
All wheel bearings are lubricated and sealed. Do not need to lubricate
them.
●
Check if there is loose phenomenon for wheel hub, drive device, and
chair itself, if loose, please screw tightly in time.
WARNING!
Please be sure the tire pressure is within 230KPa±10%.
Please inflate the tires with regulated air source and check
with pressure gauge. Do not exceed the pressure range,
otherwise may cause exploded tires or personal injury.
( Figure 11)
9.1.5 Daily Checks
In order to keep the wheelchair in good condition, you should check
before each use. And to maintain the weekly, monthly, semi-annual
investigation, check the project see (Table III).
9.1.6 Cleaning
Way of cleaning as below:
●
Never wash your wheelchair with water or expose directly to water.
●
Surface of wheelchair frame is coated with a protective coating.
Therefore, it is very easy to wipe it clean with a damp cloth. Never
use any chemicals to clean the vinylon seat and armrest, as they may
cause the latter slip or chapped. You can use a damp cloth and neutral
soapy water to clean them, and then dry thoroughly.
9.2
Repair
9.2.1 Users could repair or replace some spare parts like push handle,
push handle cover which could be self-maintained or replaced by users
under the instructions of after-sales service staff of our corporation or
the dealers’.
9.2.2 Within the warranty, our corporation or the dealers will maintain or
replace the faulted spare parts, like motor, battery, charger, controller,
bearing, shaft sleeve, etc., due to material or manufacturing defects free
of charge.
9.1.4 Maintenance after use
●
Turn off the power.(please disconnect all the connectors if not use
for long time.)
●
Inhibit children and unconscious person to use the wheelchair.
●
Store the wheelchair in normal temperature to prevent reformation
so that it keeps its performances for long period.
●
Clean the wheelchair with a clear and soft cloth and dry it. Never
use any chemicals to clean it.(to prevent deformation and discoloration)
●
Remove the cloth cover of the seat rest to be washed if it is dirty,
and then dry it for use.
19
20
All parts
Joystick function
Brake System
Connectoin
Battery Condition
Tire Condition
Frame Condition
Front Wheel Condition
Pureness
Inspection Items
At any time Weekly
Monthly
Six monthly
9. MAINTENANCE