Owner’s Manual — Sunlawn EM--2
10
CLEANING
After using the mower, clean with a moist cloth. Spray the cylinder
and cutting bar with silicon spray lube.
GENERAL MAINTENANCE
Regularly check to insure that all bolts, nuts, and screws are tight and
that the mower is in good working order. Worn out and damaged parts
should be replaced.
The blades, if properly cared for, will mow for years before requiring
sharpening. Sharpening can only be done by a professional using
a cylinder grinder and proper techniques.
STORAGE
1.
Store the EM-2, fully charged, in a cool, dry place.
2.
The batteries need not be removed for winter storage unless they
will be subject to sub-zero temperatures.
3.
The mower should be stored out of the reach of children.
READJUST THE BLADE CLEARANCE
The blades are optimally adjusted from the factory. However, after
using the mower for a long period, if the cut is not clean, the blades
need readjusting. The procedure is as follows:
1.
Turn off the mower.
2.
Set OFF/RESET switch to OFF. Make sure the battery cover is
locked. [Part # 32]. Note: If the battery cover is not latched
and the mower is not upright, the batteries can fall out,
causing damage to the batteries or electric circuits.
3.
Turn the mower over to expose the cutting bar on the bottom of the
mower. [Part # 17].
4.
Using a 10mm open end wrench, tighten the hex bolt approximately
1/4 turn [Part # 19] at one end of the cutting bar until the cutting
bar and cylinder come into contact. Spin the blade cylinder by hand
and back off the bolt approximately 1/8 turn or until the cutting bar
and cylinder are no longer in contact.
