3-4
3. Assembly Instructions
Step 1
Lay parts on ground as shown.
Step 2 Attach big screen (A) to small screen (B) using screw (R) and washer (X).<Fig. 1> Repeat this procedure for
other screens. Then place these 4pcs completed screens (A&B) upright and set them at four corners to
form square approximately 12 x 10 feet across.
Step 3 Attach 3-way fittings (P) to completed screens (A&B) using screws (X1) and washers (W1).<Fig. 4> Repeat
this procedure for other screens.
Step 4 Connect 2 completed screens (A&B) with pole (C) by screws (S) and washers (X) in the side 10 feet length.
Repeat this procedure for opposite side. <Fig. 2>
Step 5 Insert pole (E) into pole (D), fastened by screw (X1) and washer (W1). <Fig. 3> Then attach this connected
pole (D&E) into 2 completed screens (A&B) by screw (S) and washer (X). Repeat this procedure for
opposite side. <Fig. 2>
Step 6 Insert one end of pole (I) into 3-way fitting (P), the other end into mosquito net connector (Y1) as shown in
Fig. 4 & 5.
Repeat this procedure for opposite side.
Step 7 Insert one end of pole (J) into 3-way fitting (P), the other end into mosquito net connector (Y1) as shown in
Fig. 4 & 3.
Repeat this procedure for opposite side.
Step 8 Insert arm connector (L) and arm connector (K) into 4-way fitting (Q), fasten by screw (X1) and washer (W1)
to form a square as figure.
Step9 Insert one end of pole (F) into 3-way fitting (P), the other end into 4-way fitting (Q).
Repeat this procedure for
opposite side.
Step10 Insert one end of pole (G) into arm connector (K), the other end into mosquito net connector
(Y1) and
fasten it together with mosquito net connector (Y1) and pole (C) by screw (X1) and washer (W1).
<Fig. 5>
Repeat this procedure for opposite side.
Step11 Insert one end of pole (H) into arm connector (L), fasten the other end with mosquito net connector (Y1)
and connected poles (D & E) together by screw (X1) and washer (W1). <Fig. 3> Repeat this procedure for
opposite side.
Step12 Put big canopy (V) over the frame, and fit it into frame.
Step13 Insert pole (M) into extreme connector (N). Put small canopy (U) over the extreme frame, fit canopy corners
to the top part of extreme poles (M), and then insert the whole completed extreme top into 4-way fitting (Q).
Step14 Put shelf (O) into completed screens (A & B). Hang mosquito net (Z1) up to the top part of poles (I) and
