them by screw R,BUT DON’T FIX THE TWO HOLES NEXT TO JOINT ON F1 IN THIS MOMENT( fig
3).
step8. Make sure the holes on the G1 and unfixed holes on frames are lined up, attached G1 to the
connected frames by inserting screw R, fix them tightly by screwdriver.(fig 3)
step 9. Repeat above steps to connect the C1/C2 and D1/D2 for assembling them to a rectangle frame.
step 10.Connect the G1 to N, the two parts will be attached together by night lock.(fig4)
Fig.4
N
G1
E1
B1
step 11. Repeat the step10 to connect the short beam L to the K on the attached part B1&C1 by the night
lock, connect the long beam M to K on attached part D1&E1.(fig5)
Fig.5
K
L
B1
C1
step 12.Join the top connectors with beam and bar by inserting the connected set P&L,M,N into the top
connector O, fix them tightly by night lock. Do make sure the 45°bars are inserted into the higher
connectors while 90°beams are inserted into the lower connectors during this process. after this
step , your top assembly should as shown in the fig.6. Then put the big canopy over the
assembled top frame, and small canopy over the big canopy. Connect the finial P with O by
inserting screw R through O, canopyS, securing them tightly with screwdriver. Insert the slip
hooks around the canopy to the slot on frame B1,C1,D1,E1.The top frame as shown in second
picture of fig 6 now.