Step 2.
Connect one end of mosquito net pole (I or J) on corner connector (D or E) by bolt (S) as Fig. 2-1.
Connect the other one end of mosquito net pole (I or J), support connector (F) and rail (B or C) by bolt (U) as Fig
2-2.
Step 3.
Connect top support pole (K), 4-way fitting
(L) and middle connector (M) as Fig.3-1 shown.
Insert short support pole (G) into 4-way fitting (L) and middle connector (M), and insert long support pole (H) into
4-way fitting (L) as Fig. 3-2 shown. Now, the top frame is got ready.
Then assemble top frame to completed oblong frame in Step. 2.
Insert long support pole (H) to corner connector (D or E) as Fig. 3-3 shown,
And Insert short support pole (G) to support connector (F) as Fig. 3-4 shown.
Put big canopy (W1) over the top frame. --- Do not expand it because it will affect the assembly for extreme top.
Step 4.
Inert extreme top support pole (N) and extreme top pole (O) to 3-way fitting (P) as shown in Fig 4-1. Now,
extreme top frame is got ready. Put small canopy (W2) over the extreme top frame. And put the welded bolt on
3-way fitting (P) through into the pre drilled hole in small canopy (W2). Tighten small canopy (W2), fit 4 corners to
the end of extreme top support pole (K). And screw top arrow (Q) to the welded bolt on 3-way fitting (P) <Fig.
4-1>; Then assemble extreme top to big top. Attach extreme top support pole (N) to long support pole (H), fasten
by bolt (R) and nut (T) as Fig. 4-2. Tighten all hardware by screwdriver and wrench (Y). --- Do not overtighten.
Now, the top is got ready.
Step 5.
Put big canopy (W1) over the top frame --- Do not tighten. . Raise completed top up. Assemble column
