November 16 (
实际生产日期
)
Made in China
3 / 5
ASSEMBLY STEPS
Step 1:
Inset Connector (I) into Back panel (D) and secure
them with Bolt (H15), Spring washer (H3) and Flat
washer (H4), do not tighten them at this step. Repeat
the same step to the other side.
Step 2:
Inset the other end of Connector (I) into Seat panel
(C) and secure them with Bolt (H15), Spring
washer (H3) and Flat washer (H4), do not tighten
them at this step.
Secure Chair back (D) and Seat panel (C) with Bolt
(H2), Spring washer (H3) and Flat washer (H4).
Tighten all bolts here.
Step 3:
Attach Rear bar (F) to Left armrest (B) with Bolt (H15),
Spring washer (H3) and Flat washer (H4), do not over
tighten. Repeat the same step to Rear bar (F) and Right
armrest (A), do not over tighten.
1
2
