5.2 Ignition and setting control
1. Make sure control valve is OFF.
2. Turn on gas tank valve.
3. Press in and turn control valve knob counterclockwise to LOW to
HIGH
.
See the figure to the right.
4. If burner is lit, continue pressing in the control valve knob for a minute
to heat the thermocouple. If not, turn control valve knob clockwise to
OFF. Wait for 5 minutes then start with step 3 above.
5. When control valve knob is released, the burner should be lit.
6. Press in and turn control valve knob to desired heat output, LOW ~
HIGH.
Warning: Lighting the patio heater improperly could lead to an unsafe condition.
NOTE:
While in use, the burner flame should be mainly blue in appearance with a small amount of yellow. The
flame can be identified by the following Figure.
B L U E
L O W
Y E LLO W T IP
S
B L U E
H IG H
L O W
1- Flame should be blue with slight yellow tips.
2- Light burner, rotate knob from HIGH to LOW. You should see a smaller flame in LOW position
than seen in HIGH position. Always check flame prior to each use. Perform flame check prior to
each use. If only low flame is seen refer to “Burner flame is low” in the Troubleshooting Section.
5.3 Shut down
3.3.1 Turn control knob clockwise to OFF to shut down the patio heater
3.3.2 Open the door of cylinder cabinet and turn off gas supply at gas supply cylinder.
3.3.3 Disconnect by unscrewing counter-clockwise the connecter of the regulator and remove the gas
cylinder when the patio heater is not in use.
6. STORAGE
Allow at least 45 minutes for the heater to cool down after using.
Disconnect and remove cylinder if stored indoors.
Store the propane tank in a cool, dry and well ventilated area, out of the reach of children, and not
in a building, garage or any other enclosed area.
Store the heater upright in a sheltered area away from inclement weather and dust.
If desired, cover the heater after the heater is cool.
Storage indoors is permissible only if the propane tank is disconnected and removed from the
appliance.
Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed
from the appliance.
A cylinder must be stored outdoors in a well-ventilated area out of the reach of children.
A disconnected cylinder must have dust caps tightly installed and must not be stored in a building,
garage or any other enclosed area.
Fig.19 Incorrect flame
Fig.20 Correct flame
OFF
HIGH
MAX
BAS
ARRET
LOW
3
1
of
3
4
Country of Origin: China
Pais d’origine: Chine
Summary of Contents for AMBERCOVE A306007400
