Tools required: ladder, hammer, screwdriver (not included)
Fig.1: Insert both ends of short support pole ( 4 ) into long support pole ( 3 ), then insert the other end of
long support pole ( 3 ) into 90 degree angle tube of corner connector ( B ), make sure the sloping pipe
upward.
Fig.2: Insert one end of lower bar ( 5 ) with shrink tube into upper bar (6), then insert upper bar ( 6 ) into top
connector (C), place big canopy (E) onto the top frame, but not expand before install the fourth upper bar
( 6 ), insert the fourth upper bar (6 ) into top connector (C) under big canopy (E) .
Fig.3: Insert the other end of lower bar (5) into the sloping pipe of corner connector (B), place small
canopy (D) onto the top frame.
