11
3. With the removed power head in the upside down
position, carefully remove the HEPA filter from the filter
cage (Fig. 12).
4.
Clean the HEPA filter by gently tapping or brushing dirt off.
Cleaning should not be done indoors in living areas.
5. If needed, use a mild soap and water solution to wash the
HEPA filter and rinse with clean water. Allow the wet filter
to air dry for 24 hours before installing onto the filter cage.
m
WARNING!
The HEPA filter must be installed before dry
vacuuming again.
Cleaning the Foam Filter
m
WARNING!
The foam filter must be cleaned every time
after wet vacuuming.
1.
Switch off and unplug the unit.
2. Remove the power head from the collection tank.
3. With the removed power head in the upside down
position, carefully remove the foam filter from the filter
cage (Fig. 13).
4.
Use a mild soap and water solution to wash the foam filter
and rinse with clean water. Allow the wet filter to air dry for
24 hours before installing onto the filter cage.
5.
To assemble the filter, fit the foam filter on the filter cage
(Fig. 14).
Storage
1. Examine the electric wet/dry vacuum thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
®
+
Sun Joe
®
dealer or call the Snow Joe
®
+ Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Examine the appliance cord thoroughly for signs of
excess wear or damage. If it is worn or damaged,
replace it immediately.
3. Store the wet/dry vacuum indoors in a clean, dry and
locked location out of the reach of children and animals.
4. When not in use, the equipped tubes, handles and nozzles
can be temporarily stored in the onboard vacuum hose +
power cord storage and onboard accessories storage
(Fig. 15).
Fig. 12
HEPA filter
Fig. 13
Foam filter
Fig. 14
Foam filter
R
Fig. 15
Onboard accessories
storage
Onboard vacuum hose +
power cord storage