Support Stand Assembly
NOTE:
Due to the weight of the log splitter, we
highly recommend assembling the unit with the
help of at least one other person.
1.
Fix the beam, front post and the two
brackets together using four sets of bolts,
washers and lock nuts (Fig. 4).
2.
Slide the other end of the beam through the
support stand axle, then loosely thread the
screw knob into the nut (Fig. 5).
NOTE:
Do not tighten down the screw
knob yet.
3.
Slide the wheels onto the support stand
axle and secure them in place using the
retaining rings (Fig. 6).
Fig. 4
Bracket
Lock
nut
Washer
Bolt
Fig. 5
Support
stand axle
Screw knob
Beam
Fig. 6
Support
stand axle
Wheel
Retaining
ring
Retaining
ring pliers
4.
Snap the hub caps back onto the wheels.
5.
Install both rear posts onto the log splitter
axle through the bottom holes (Fig. 7).
6.
Insert the other end of both rear posts
through the vertical box sections on the
support stand axle. Tighten using the two
remaining screw knobs (Fig. 8).
7.
Pivot the log splitter so that the front stand
mount rests on top of the front post. Fix
them together using the nuts and bolts
disassembled from the front stand (Fig. 9).
NOTE:
The front post may need to shift
forwards or backwards in order to match
the bottom of the front stand mount. This is
why the middle screw knob should only be
threaded on loosely.
Fig. 7
Rear posts
Log splitter axle
Fig. 8
Rear
posts
Support stand axle
Screw
knob
Fig. 9
Front
post
Front stand
mount
Bolt
Bolt
Nut
4
