Product Specification and User Manual
®
Using the Speakerphone
Once pairing is completed, you may access the following functions. Some of the below-mentioned function is
only accessible for handsets supported with Hands-Free Profile.
(a)
Answering a Call:
To answer a call, wait for the speakerphone to ring, then short press the MFB to accept the call or answer
the call via your mobile handset in the normal way.
(b)
Ending a Call:
Short press the MFB, to end your call or end the call via your mobile handset in the normal way. Mean
while you can hear a short beep from the speaker.
(c)
Reject a Call:
When you hear the ringing tone, press and hold the MFB for 3 seconds until you hear a short beep.
(d)
Voice Dialing:
If your mobile handset is voice dialing enabled, under standby mode, press the MFB and when you hear a
beep, say the voice tag.
IMPORTANT:
Please make sure to record voice tag into the mobile handset before using voice dialing
function. This function is only applicable to mobile handset with Bluetooth Hands-Free Profile.
Because of variation of different phone, some of the phones, you may not hear the beep. Please refer to
your mobile handset user guide for additional information.
(e)
Last Number Re-Dialing:
Under standby mode, short press MFB twice for last number redial.
(f) Privacy Handset:
During conversation in progress, press the “MODE” button. Speaker and mic volume will be decrease with
LED flash blue. You may now use the speakerphone as a normal handset.
(g)
Adjusting the Volume:
During conversation in progress, press the volume button repeatedly until you reach the desired volume
level.
(h)
Mute & Un-mute:
To mute the speakerphone, press the “MODE” button for 3 seconds. Mean while, the LED flashes red.
To un-mute the speakerphone, press button again.
(i) Call
Inter-Changing:
(1)Speakerphone to Handset:
：
During conversation in progress, press and hold the V+ & V-
simultaneously.
(2)Handset to Speakerphone
：
Press the MFB.
Restore to Default-Remove Previous Pairing & Connection
You may want to reset the speakerphone to its original settings and clear the previous pairing. Please follow
these simple steps.
(a) Ensure the speakerphone is under standby mode.
(b) Press and hold the volume increase & decrease buttons simultaneously for 10 sec. until LED flashes blue
& red alternatively. Release the buttons.
(c) Again, press and hold the volume increase & decrease buttons simultaneously for 2 sec. until
speakerphone emits 2 short beeps. The speakerphone will be powered off and back to default setting.
(d) After defaulting, if speakerphone is power on again, the LED will flash red every 3 seconds and
speakerphone will emit 3 beeps every 1minute. Then, the speakerphone will be powered off within 2
minutes. This is normal. The speakerphone will be back to normal after completion of pairing with
Bluetooth devices.
BT-02A2 www.sunitec.com.tw
第
5
页
,
共
5
页
