ASSEMBLY
6. Install Reflector. NOTE: MAKE SURE TO REMOVE PROTECTIVE
PLASTIC COVER ON REFLECTOR PIECES PRIOR TO ASSEMBLY!
Assembly Tip: If necessary for proper alignment of reflector sections,
loosen each screw prior to further assembly and retighten after sections
are aligned.
Slide two Reflector Panels together. Insert one Small Screw.
Screw on Cap Nut loosely.
Repeat with the third Reflector Panel.
Slide Reflector Plate onto assembled Reflector Panels. Insert one
Small Screw and screw on Cap Nut loosely. Repeat with two more
Small Screws and Cap Nuts to complete reflector assembly. Fully
tighten all the screws and cap nuts.
Hardware Used:
9 Small Screws
9 Cap Nuts
7. Attach Reflector Assembly to heater. While supporting heater,
tilt the Head Assembly and slide 3 Large Flat Washers over the Reflector
Studs. Place the Reflector Assembly onto the Reflector Studs and slide
3 Large Flat Washers over Reflector Studs and onto Reflector Assembly.
Secure with 3 Wing Nuts. Do NOT over tighten.
Once you have tightened the Wing Nuts, return the heater to an upright
position.
Hardware Used:
6 Large Flat Washers
3 Wing Nuts
- 9 -
