64
9.14 Parameters of LCD
9.14.1 Communication Parameters
Improper communication parameter configuration may lead to communication
failure!
Follow strictly the instructions of the plant staff in configuring the communication
parameters.
Proceed as follows to set the communication parameters:
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Com-parameter” after entering the correct password.
•
Set parameter from the Address interface for address.
•
Set parameter from the Serial Port Parameter interface for baud.
•
Set parameter from the Network Parameter interface for IP address, subnet mask,etc.
- - End
9.14.2 Running Parameters
Setting Running Parameters
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Run-parameter” after entering the correct password.
step 4 Set the running parameter by tapping the pop-up keypad and tap ENTER to confirm setting.
Tap “Prev” or “Next” to turn pages up or down.
- - End
9.14.3 Protection Parameter
Setting Protection Parameter
step 1 Tap “Function” from the default menu.
step 2 Tap “Set-parameter”.
step 3 Tap “Pro-parameter” after entering the correct password.
step 4 Set the protection parameter by tapping the pop-up keypad and tap ENTER to confirm
setting. Tap “Prev” or “Next” to turn pages up or down.
- - End
System Manual
