8
WEB Interface
User Manual
26
Parameter
Description
NTP parameters
After checking "enable NTP time synchronization",
synchronize the time to the NTP server (such as PC and
Internet server)
Set server address and port number
8.7.2 Operating Parameters
Different parameters are set for the system configuration interfaces, and the
running parameter interfaces are different accordingly. Please refer to the
actual interfaces, and details are not described herein.
The Operating Parameters include the following settings.
Parameter
Description
Mode setting
Set to "Running Mode", "Power Control Mode", "Grid
Power", or "Off-Grid power"
Q-ac regulation
That includes "Close", "Power Factor", and
“
Q-ac Power
”
BMS control
Setting closing or opening of the BMS switch
Start type
Set the active or passive mode
Start
&
stop
control
Set to start or stop
Note: The table above includes all parameters that can be set, but actual
configurable parameters and interfaces may vary as per system configuration.
8.7.3 Communication Parameters
The communication parameters include the following settings:
Parameter
Description
Network 1 parameters
Default IP address: 192.168.1.100
Network 2 parameters
Default IP address: 192.168.0.100
parameters
Set the Modbus parameter and TCP port number
Summary of Contents for EMS200
Page 1: ...EMS200 V12 UEN Ver11 201812 EMS200 Local Controller User Manual...
Page 2: ......
Page 6: ...IV...
