4
Rev. 04/10/03
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOLLOWING BEFORE USING THIS TOOL
•Tighten the gun to the cup securely with the nut and fitting supplied.
•Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should be
35 PSI for lacquer and 43 PSI for enamel.
•Adjust fluid control screw and spray width adjustment screw to your desired pattern before using
on production.
•Clean all parts after use.
SPRAYING
ADJUSTMENTS
In normal use, the nozzle wings are
horizontal as shown here. This
provides a vertical fan-shaped
pattern which gives maximum,
even, material coverage as the gun is
moved back and forth parallel to the
surface being finished.
Spray pattern may be infinitely
adjusted from round to flat.
Set atomization pressure at no more than 43 PSI. For
optimum performance, some materials may spray better at
PSI ratings below 43. If unsure, always test at PSI ratings
before using on final production. Try spray. If it is too fine,
decrease the air pressure or open fluid control screw. If the
spray is too thick, close the fluid control screw. Regulate
the pattern width and repeat adjustment of spray
as needed.
Fluid control screw
Turn right to decrease flow, left
to increase.
HVLP S
PRAY
G
UN
The model you have purchased is a
professional high volume, low pressure,
spray gun. It is designed to spray very
efficiently with virtually no overspray.
To accomplish this, the inlet pressure
regulation is critical. Please be sure to
read pressure requirements carefully.
Spray width adjustment screw
Turn right for round, left for fan.
90025_OpMan 4/18/03 1:57 PM Page 4
